I normally stick with PLA when I print but I decided to give ABS a shot.
Shared with: Public, Keith I Myers, Alex Minnucci+1’d by: Un Lo, Alex Minnucci, Mark Richards, Dor Kleiman, Derek Hoppas, the derek Fawcett, Smartphones, Corey Miecielica, Remigiusz Nowak, Roberto Mezquia Jr, Jesus Suarez, Rob M., Swappa, Ben Schoon, Steve KluverReshared by: SmartphonesCorey Miecielica – 2016-08-04 01:58:25-0400Yay 🙂Alex Minnucci – 2016-08-04 09:54:18-0400+Keith I Myers how do you find it? Keith I Myers – 2016-08-04 09:55:18-0400+Alex Minnucci – the biggest problem is running the heated bed in a house that is already too hot is not funAlex Minnucci – 2016-08-04 09:57:50-0400I usually heat it to 95 than lower it to 80ish about 10 layers in. Celsius ofc. Doesn’t need to always to max heatKeith I Myers – 2016-08-04 10:00:41-0400+Alex Minnucci – I have mine going to 100 for the first 30 layers (for this print) and backing off to 80 until layer 47 (which completes the entire base for this print). I keep it off while building the android robot itself